HomeMy WebLinkAbout3347-6:-9
6!
VWI'IVVIi
BRANCF
CONDUI
THE FRAME AND LID OF THE VAULT SHALL
COMPLY WITH THE LOAD RATING APPLICABLE
TO THE VAULT LOCATION AS DESCRIBED IN
THE SPECIAL PROVISIONS.
SPLICE VAULT COVER MARKED
'TRAFFIC" LETTERS TO BE
V TO 3" HIGH
P 48 SPLICE VAULT DUSYSIONS
NTS
DETAIL 'A'
INSTALLATION IN CONCRETE SIDEWALK
NTS
TOP VIEW
NTS
TRAVEL LANES
6-1 1/2" (38 mm) /
HDPE CONDUITS
OR AS NOTED ON PLANS
SPLICE VAULT
PROPOSED CURB & GUTTER
SIDE VIEW TYPICAL
SPLICE VAULT_
OR PULL BOX
NTS
�6-1 1/2" (38 mm)
HDPE CONDUITS
OR AS NOTED ON PLANS
CONDUIT
CONDUIT
SPLICE VAULT.
OR PULL BOX
DETAIL 'D'
NTS
0
2
to
2" MIN
I
10"
rnnirprr� pin►r_
DETAIL 'A'
INSTALLATION IN COMPACTED EARTH
NTS
CONDUIT TO BE
VERTICALLY ALIGNED
R=3' MIN. -
(914 mm)
SEE DETAIL A
Zx
i 1\
N
10 FT j
FOR EA
#6 COPPER WIRE ATTATCHED TO
GROUND PROVISION ON SPLICE
CLOSURE WITH A TERMINAL LUG
8' GROUNDING ROD
P 48 SPLICE VAULT CABLE TERAINA17014
NTS
INSTALLATION NOTES -
1. CONCRETE RING SHALL BE CLASS 520—C-2500 CONCRETE.
2. CONCRETE ENCASEMENT RING DIMENSION, D, TO
BE EQUAL TO DESIGN SIDEWALK DEPTH.
3• PAVEMENT AND SUBGRADE TO BE AS DIRECTED
BY THE ENGINEER.
x
These Record Documents have been prepared
based on information provided by others. The
Design Professional has not verified the accuracy
and/or completeness of this information and shall
not be responsible for any errors or omissions
which may be incorporated herein as a result
IT
►p
NOTES (THIS SHEET ONLY)
1. UPON ACCEPTANCE OF THE WORK ALL CONDUITS SHALL BE SEALED WITH COMPATIBLE
SEALANT MATERIAL.
2. ALL GROUND CONNECTIONS SHALL BE COATED WITH OXIDATION PROHIBITING COMPOUND.
3. THE VAULT SHALL BE CAULKED AFTER ALL KNOWN ENTRANCES HAVE BEEN MADE.
4. VAULT SHALL HAVE INTEGRAL BASE OR SHALL BE GROUTED PER STANDARD SPECIFICATION
OF PULL BOXES.
5. PULL BOX SHALL NOT BE WITHIN THE BOUNDARIES OF NEW OR EXISTING WHEELCHAIR RAMPS.
6. WHEN PULL BOX IS INSTALLED IN SIDEWALK AREA, THE DEPTH OF THE PULL BOX SHALL
BE ADJUSTED SO THAT THE TOP OF THE BOX IS FLUSH WITH THE TOP OF SIDEWALK.
7. ALL COVERS AND BOXES SHALL BE INTERCHANGEABLE WITH CALIFORNIA STANDARD MALE AND
FEMALE GAGES. WHEN INTERCHANGED WITH A STANDARD MALE OF FEMALE GAGE, THE TOP
SURFACES SHALL BE FLUSH WITHIN 1/8 INCH. TOP OUTSIDE EDGE OF ALL CONCRETE
COVER AND PULL BOXES SHALL HAVE A 1/4" MIN RADIUS.
rl,.,.....,.,.. u.% num,% i nnnm nDm nnnne% rn n .1.....